• Route planner
  • My activities
  • Blog
  • FAQ
Instagram Buy me a coffee
Connect with Strava
All posts

How hard is this ride? Reading the climb chart

12 November 2026

Also available in: Deutsch · Français · Nederlands

"1,200 m of climbing" tells you surprisingly little about a ride. It can be twenty gentle rollers you barely notice, or one wall at 18% that has you walking. Total ascent is the number every planner shows. How the climbing is spread out is what decides whether you enjoy the ride.

That's why the elevation chart in RouteCycle isn't just a grey shape any more. It shows how hard each part of the ride is, in colour.

What the colours mean

Each part of the profile is coloured by its gradient:

  • Green: easy, flat or gently rolling.
  • Yellow: a bit of work.
  • Orange: steep.
  • Red: really steep.
  • Dark red: very hard, 15% and more.

One look at the chart and you know whether a route is a relaxed spin or a leg-burner, and where the hard parts are.

Check the gradient at any point

Move your mouse, or your finger on a phone, over the chart and it shows how steep that exact spot is. It's the quickest way to answer questions like "is that climb at km 40 steady, or does it kick up at the top?".

Steepest climb and steepest descent

The route also shows two extra numbers: the steepest climb and the steepest descent on the whole route.

The steepest climb matters because it's the part you can't avoid. A route with modest total ascent but one 17% ramp is a very different ride from one with the same ascent spread out evenly, especially on a loaded touring bike or with tired legs at the end of the day.

The steepest descent matters for a different reason: safety. A steep descent on a narrow road, in the wet, on a gravel bike, is where things go wrong. It's better to know about it before you're on it.

How to use it when choosing a route

When RouteCycle gives you a few route options, the chart is often the fastest way to choose between them:

  • For an easy day, pick the route that's mostly green and yellow, even if it's a bit longer.
  • For training, look for one long orange section rather than lots of short red spikes. Steady climbs are better for pacing.
  • On a gravel bike, be careful with red and dark-red sections on unpaved roads. Steep and loose is much harder than steep and smooth.
  • Late in a long ride, check where the hard part sits. A red climb at km 15 is fine. The same climb at km 140 is a different story.

If you want less climbing in general, use time mode with the elevation slider to cap the total ascent.

A note on accuracy

Elevation data comes from digital elevation models, which are measured from above. On open roads they're good. Where a road runs through a narrow valley, along a cliff, or over a bridge, the model can see the ground next to the road rather than the road itself, and you can get a short fake spike. If a single red spike looks suspicious, it probably is.

Open the route planner, generate a route and look at the chart under it.

Read next

  • Plan your ride by time, not distance
  • Gravel routing: most roads don't say what they're made of
  • From route planner to Garmin in one click

Want a quiet ride from your door? Pick a start and a distance, and RouteCycle builds the loop.

Open the route planner
FAQBlogRoutesTerms & ConditionsPrivacy Policy